Highview Garage’s tips on how to pass your MOT test
Close to 40% of cars fail their MOT first time and often minor faults that coudl have been avoided. Exact stats are availble via the DVLA here.
Before you book your test, check our tips on checks you can make in the comfort of your driveway, street at home or local petrol station. These will ensure you don’t fail on a fault you could have avoided. Remember, your annual MOT test covers a number of your car’s key components, and every car over 3 years old must pass it to comply with UK law.
Car lights and bulbs
Close to 20% of cars fail the MOT test due to faulty lights, signalling issues or both. All of yor key lights must be working in order to pass your MOT test. The lights you must check are the following: headlights, side lights, brake lights, indicators and registration plate bulbs. We recommend you turn them on (ideally in the dark or not during strong daylight hours) and walk around your car. If you do check them during strong daylight you may want to use a reflective surface, such as your garage door, to check the bulb’s efficiency. If a bulb is not working or weak, make sure you get it changed before your MOT test or have in changed in your regular service.
Car brakes
Brakes are some of the most common causes of MOT test fails. Without the correct equipment, assessing them will not be possible. However, checking your brake fluid is between the minimum and maximum markers on the fluid reservoir will make sure you do not fail on this small point. If you’re unsure book a Free Brake Check.
Car registration plate
Believe it or not, a damaged or dirty registration plate can result in a fine of £1000 and a failed MOT test. Make sure yours is clean, clearly visible and securely fastened to your car.
Car suspension
Apart from absorbing the bumps and curbs when parking, your suspension allows you to accelerate, brake and corner safely. Hence why car supspension is classed as a critical component and must be both operational and in good condition to pass the MOT test. Like brakes, without the correct equipment, this can be difficult to test at home but our dedicated page on brakes and shock absorbers provides some outlines for this.
Car tyres
Close to 10% of MOT test failures are due to tyre conditions. Your tyres require a minimum tread of 1.6mm (the current legal limit) and be free from lumps and cuts in the side walls. The 20p coin test is something you can do at home to determine your tread and close observation of your tyres for the general condition will allow you time to change or repair before an MOT test.
Car body
Your car s body needs to be free from cracks, dents, sharp edges and corrosion, and be clean enough for an MOT tester to inspect it fully. The MOT tester will check that all doors and locks work, and boot. Even your fuel cap will be checked.
Car mirrors
Both your internal rear view mirror and wing mirrors have to be visible from the driving position and securely fastened. We recommend you clean, angle them correctly and wash all before your MOT test.
Car windscreen, wipers and washers
During your MOT test your windscreen will be checked for any significant chips and cracks to determine that the driver’s view of the road is unobstructed. Remove any potential obstructions such as sat navs or dangling air freshners in the window. Your windscreen and rear window wipers will be checked to see if they smear or squeak. Check them thoroughly and change if necessary before your test. Washer fluid should also be topped up.